If a lightweight AP provides at least one BSS for wireless clients, which one of the following modes does it use?

Which address and wildcard mask combination can be represented with the keyword ”any”?

How is Telnet used to verify connectivity? (Choose two)

Which aspects can you check to verify that IPv6 is configured correctly? (Choose three)

Looking at the exhibit, what key:value pair option has a value that is numeric in nature?

Which address and wildcard mask combination will match all IPv4 addresses in the networks 172.30.0.0/24 through 172.30.15.0/24?

Which of the following reserved IPv4 addresses is used in DHCP assignment process before a host has a valid IP address?

Which IPv6 address is the equivalent of the IPv4 interface loopback address 127.0.0.1?

A Cisco Catalyst switch connects to what should be individual user PCs. Each port has the same port security configuration, configured as follows:
interface range gigabitethernet 0/1 - 24
switchport mode access
switchport port-security
switchport port-security mac-address sticky
Which of the following answers describe the result of the port security configuration created with these commands? (Choose two)

Which DSCP marking group was created to be backward compatible with Internet Protocol Precedence (IPP) values?

Which of the following are required attributes of a REST-based API? (Choose two)

Which problems can manifest in a redundant switched topology? (Choose three)

Which command is used to create a backup copy of your Cisco IOS image and store it in a TFTP server?

Which of the following describes a multicast type of network communication?

Refer to the exhibit. What will Router1 do when it receives the data frame shown? (Choose three)

Which of the following use cases are matching the Fiber Ethernet media type? (Choose two)

Which of the following parameters are necessary when creating a new WLAN with the controller GUI? (Choose two)

What will occur automatically on a Cisco IOS router when you configure the interface to obtain an IPv4 address via DHCP and the DHCP server hands out IP address, subnet mask, and default-gateway information?

What source will be chosen when a destination network offers multiple sources?

R1, R2, R3, and R4 have their Fast Ethernet 0/0 interfaces attached to the same VLAN. A network engineer has typed a configuration for each router by using a word processor. He will later copy and paste the configuration into the routers. Examine the following exhibit, which lists configuration for the four routers, as typed by the network engineer. Assuming that all four routers can ping each other’s LAN IP addresses after the configuration has been applied, choose the routers that will be able to form a neighbor relationship with the other routers on the LAN. (You can assume that, if not shown in the exhibit, all other related parameters are still set to their defaults.) (Choose two)

You have implemented DAI on a Layer 2 switch in your network. Now you want to monitor the ARP message rates with an average of four received ARP messages a second. Which command(s) would need to be utilized to accomplish this? (Choose two)

Which protocol provides encryption only?

An enterprise plans to start using a public cloud service, and is considering different WAN options. The answers list four options under consideration. Which options provide good security by keeping the data private while also providing good QoS services? (Choose two)

Which layer in the OSI reference model is responsible for determining the availability of the receiving program and checking to see if enough resources exist for that communication?

Review the topology. All subnets exist in OSPF area 0. Which command, if issued on R3, would show all the LSAs known by R3?

What is the calculator of the total cost of a particular path referred to?

What options are required criteria for a service to be a cloud service? (Choose two)

Robust wireless encryption is based on which of the following algorithms?

enable secret [password]​ is hashed using the _______ algorithm.

A network uses an SDN architecture with switches and a centralized controller. Which of the following terms describes a function or functions expected to be found on the switches but not on the controller?

Which of the following OSPF packet types describes the network routes of each neighbor?

Which command is used to set an inactivity timer for the vty lines on your Cisco IOS switch?

Which Cisco IOS command is used to advertise a default route into an OSPF domain regardless of whether a default static route is configured?

What are the valid encapsulation methods when forcing a device to become a trunk port? (Choose three)

When a wildcard mask is presented in binary, what do the zeros (0) indicate?

Refer to the diagram. What is the name of the device referenced with the arrow, assuming the traffic coming from the wireless clients followed the dashed path?

A user is experiencing a loss of end-to-end connectivity in an IPv4 network. You have verified that the name resolution entry is correct. Now you want to check whether any IP ACLs are set on the interface. Which command should you use to do so?

What commands would you need to configure to enable DHCP Snooping so that PC4 couldn’t become a rogue DHCP server?

Which of the following QoS marking fields could remain with a packet while being sent through four different routers, over different LAN and WAN links? (Choose two)

During a maintenance window, you make some changes to R2. You document these changes in your configuration management system. Later that night, you are called in to fix an issue that requires you to make additional changes to R2. The next morning your co-worker addresses another issue but this time on R1. All of these changes are documented properly but neither you or nor your coworker discuss the changes. These changes stay implemented for months. What is this best described as?

Based on the network shown in the graphic. Which option contains both the potential networking problem and the protocol or setting that should be used to prevent the problem?

Convert the MAC address “b838.61ad.7340“ into an IPv6 EUI-64 interface identifier.

Which command is used to generate local RSA keys that will be used for SSH connections to a Cisco IOS device?

In a reflection attack, the source IP address in the attack packets is spoofed so that it contains which one of the following entities?

It is typical for server processors to utilize a technique that allows each physical processing core to be split into a number of virtual cores; this is commonly referred to as __________.

Refer to exhibit. Which destination addresses will be used by Host A to send data to Host C? (Choose two)

Which QoS feature is typically used inbound to a network to limit the amount of traffic that is allowed to flow in?

Which command enables IPv6 forwarding on a Cisco router?

Review the topology diagram. Network 10.123.0.0/24 is the backbone area. Network 10.12.0.0/24 is area 1, and network 10.34.0.0/29 is in area 2. Which of the following are true? (Choose three)

Which DSCP Assured Forwarding value provides the worst drop and worst queue performance?

Which command is used to import a static default route into the RIP routing process and have it advertised to other neighboring RIP routers?

Which end-to-end connectivity troubleshooting tool displays and modifies entries stored as IP addresses and their resolved MAC addresses?

Using the exhibit as a reference, how many JSON objects are there?

What are the benefits of using Cisco IOS NetFlow? (Choose two)

You want to verify the Cisco IOS software version, ROM version, amount of memory, type of processor, number and types of interfaces, as well as the configuration register value on your 2900 series IOS router. What command will allow you to accomplish this?